On the right is our programming adaptor, it has a USB – Serial interface, a switch configured for the BOOT pin (marked orange), and a switch configured for RESET (marked red).įor the STM32F091, BOOT is set HIGH, RESET is pulled LOW by the switches. ![]() In the middle is the DEV010B oLED display board with a STM32F091 on board On the Left is a USB – Serial interface – this interface provides power to the DEV010B board, and the serial is used for the application communications (in the application pictured it is for MODBUS) ![]() Typical STM32F091 DEV010B Programming Setup
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |